Jump to content

Close

wagonburner

Member Since 15 Feb 2013
Offline Last Active Aug 09 2013 03:29 AM
-----

Topics I've Started

changing shaft on my trolling motor

08 August 2013 - 12:45 AM

broke my carbon fiber shaft the other night it broke in half luckily i had another old motor with carbon shaft. pretty much take out all the guts and magic mark housing across so you put back together right if you flip flop your forward is reverse and reverse is forward speaking from experience here. and start applying heat on the motor part (aluminum) not the shaft heat all the way around then try to unscrew. if no movement apply some more heat. took me 3 tries of heating before coming unscrewed. when unscrewing if starts to get hard again apply more heat if you muscle through it you will probably lose some of the threads of the shaft like i found out on the initial motor which was the unbroken shaft.after learning this the broken shaft come out perfect. so a little jb weld on threads screwed in shaft so far so good. hope this helps somebody

 

Attached File  20130719_084414.jpg   148.59KB   150 downloadsAttached File  20130719_084436.jpg   118.87KB   143 downloadsAttached File  20130719_084533.jpg   147.66KB   160 downloadsAttached File  20130719_084615.jpg   105.25KB   144 downloads[attachment=609:20130719_084922.jpg]

my new toy i just finished

10 June 2013 - 11:51 PM

Attached File  20130610_193426.jpg   91.2KB   135 downloadsAttached File  20130610_193449.jpg   115.06KB   148 downloads

caspian wide body titanium frame and ionbonded coated in 40 cal 

convenient tool kit

21 March 2013 - 11:44 PM

found this electrician tool belt at garage sale cheap and pulled one of the pouches off and screwed it to deck and put some common tools in that i use often while fishing. so when reel seat comes loose or light needs adjusting you aint digging for pliers or wrench. if your boat is like mine you have crap everywhere and cant remember where you put anything.

generator help

17 March 2013 - 02:11 AM

was going out tonight to try everything out for the season changed oil and spark plug on generator (powermate 8750 with yamaha motor) started fine but is not putting out any electric. any clues? 

my running light fix

14 March 2013 - 02:12 AM

used to break my running light (the white one) quite often. always forgot to remove it when i got to the fishing hole. removed my light and wires from tube then measured up about ten inches from base and then cut it with hacksaw. found a old trampoline spring that fit perfect on mine. mixed up some JB weld then slid spring on couple inches on one side of tube then did the same to other side. had to splice a few more inches of wire to compensate for spring length. put all back together but it was a little too springy for me so started wrapping spring with electrical tape till i was happy with the movement. hasn't broke yet been using for 6 years.